Influence of change of tunnel axis angle on tunnel length during double-bundle ACL reconstruction via the transportal technique

Abstract

Background

Commercially available flexible reamer and curved guide systems allow a certain degree of control over intra-articular tunnel orientation, therefore allows a wide range of intra-osseous femoral tunnel orientations, contrary to the femoral tunneling technique using a straight guide pin, which are determined by knee flexion angle. We sought to find the clinical relevance of intra-osseous femoral tunnel orientations in the respect of tunnel length. To evaluate the relationship between the tunnel axis angle in three orthogonal planes and tunnel length in the anteromedial (AM) and posterolateral (PL) femoral tunnels in patients who underwent anatomic double-bundle anterior cruciate ligament reconstruction (DB-ACLR) using the transportal (TP) technique with a 42^o curved guide.

Methods

A total of 40 patients who underwent primary DB-ACLR with the TP technique using a curved guide were evaluated retrospectively. The tunnel axis angle in three orthogonal planes were evaluated on a three-dimensional surface model constructed using an axial computed tomography scan obtained after reconstruction. Then, correlations with tunnel length were analyzed.

Results

In the AM tunnel, tunnel axis angles in the coronal (β = 0.0252, p = 0.022) and sagittal (β = 0.0168, p = 0.029) plane showed significant correlations with tunnel length, while the axial plane did not (p = 0.493) (adjusted R² = 0.801). In the PL tunnel, only tunnel axis angles in the axial plane (β = 0.0262, p = 0.008) showed a significant relationship with tunnel length (adjusted R² = 0.700).

Conclusion

Drilling at a higher angle in the coronal and sagittal planes in AM tunnels and at a higher angle in the axial plane in PL tunnels decreases the incidence of short femoral tunnels.

http://ift.tt/2qBdnwE


http://ift.tt/2rEXVjw